SciELO - Scientific Electronic Library Online

 
vol.42 número2On the Optimal Reconfiguration of Radial AC Distribution Networks Using an MINLP Formulation: A GAMS-Based ApproachAn Efficient Algorithm Applied to Optimized Billing Sequencing índice de autoresíndice de assuntospesquisa de artigos
Home Pagelista alfabética de periódicos  

Serviços Personalizados

Journal

Artigo

Indicadores

Links relacionados

  • Em processo de indexaçãoCitado por Google
  • Não possue artigos similaresSimilares em SciELO
  • Em processo de indexaçãoSimilares em Google

Compartilhar


Ingeniería e Investigación

versão impressa ISSN 0120-5609

Resumo

MUNOZ, Christian Daniel et al. Low-Timing-Jitter and Low-Phase-Noise Microwave Signal Generation Using a VCSEL-Based Optoelectronic Oscillator. Ing. Investig. [online]. 2022, vol.42, n.2, e205.  Epub 08-Jun-2022. ISSN 0120-5609.  https://doi.org/10.15446/ing.investig.v42n2.87189.

This article presents the first results of the timing-jitter characterization of a VCSEL-based optoelectronic oscillator (VBO) at 2,5 GHz. For all implementations, vertical-cavity surface-emitting lasers (VCSEL) emitting in the O and C-bands were characterized. The resonant cavity was modified through the optical delay line length to verify its impact on timing-jitter and phase noise of the VBO. The lowest peak-to-peak jitter value obtained experimentally was 71 mUI when the optical fiber length was 1 km, whereas the lowest phase noise was -124 dBc/Hz with 5 km. This phase noise value, measured at 10 kHz offset, represents an 8 dB improvement compared to previous results, and it is the lowest value reported in the literature for the VBO architecture at 2,5 GHz.

Palavras-chave : jitter; optoelectronic oscillator; phase noise; VCSEL; optical fiber.

        · resumo em Espanhol     · texto em Inglês     · Inglês ( pdf )