Serviços Personalizados
Artigo
Indicadores
Citado por SciELO
Acessos
Links relacionados
Citado por Google
Similares em SciELO
Similares em Google
Compartilhar
Revista Facultad de Ingeniería Universidad de Antioquia
versão impressa ISSN 0120-6230
Resumo
CARDONA MAYA, Yamile; GOMEZ CARDONA, Nelson e TORRES TRUJILLO, Pedro Ignacio. Low cost heat-and-pull rig for manufacturing adiabatic optical fiber tapers. Rev.fac.ing.univ. Antioquia [online]. 2014, n.70, pp.167-172. ISSN 0120-6230.
In this paper we report the fabrication of adiabatic tapered optical fibers using a low cost heat-and-pull rig. Our setup is based on the flame-brushing technique moving in zigzag, where an inexpensive and simple portable gas micro-torch is used as heating device. Since this method does not require an electronic system to control the gas flow rate, makes out taper rig an attractive alternative, low-cost, and trivial to implement. The feasibility of such a heat source is shown with the manufacture of low-loss tapers (<0.12 dB/mm) and diameters in the micro range.
Palavras-chave : Optical fiber; tapering; adiabaticity; sensors.