Resumo

MARULANDA-BERNAL PH. D., José-Ignacio; GALLO-CASTRILLON M. SC., Wilson-Henry  e  MOSQUERA-PALACIO, Diana-Marybel. Microwave Frequency Characterization of Barium Titanate Films Obtained Via Sol-Gel. Rev. Fac. ing. [online]. 2020, vol.29, n.54, e10416.  Epub 30-Jan-2020. ISSN 0121-1129.  https://doi.org/10.19053/01211129.v29.n54.2020.10416.

The present work focuses on the structural, morphological and dielectric characterization of barium titanate films (BTO or BaTiO3 due to its chemical formula) deposited by spin coating on crystalline silicon (Si) substrates and CPW resonators using the Sol-Gel technique with a Ba/Ti molar ratio of 0.5/0.5. The coplanar waveguides were manufactured on alumina substrates (Al2O3) with 3 μm of gold (Au) metallization using the laser ablation technique. The scanning electron microscopy (SEM) with X-ray energy dispersion spectrometry (EDS) showed the existence of a BTO film with an elementary composition of 14.62% barium and 5.65% titanium, with a thickness of 0.77 μm measured using the profilometric mode of the atomic force microscopy (AFM). Dielectric characterization was carried out by comparing the frequency response (parameter S21) of a CPW resonator with deposited BTO film and another reference resonator (without film) using a network vector analyzer (VNA). These measurements are compared in turn with computational simulations to obtain the dielectric properties. For the BTO film a relative dielectric constant (ɛr) of 160 was determined with a loss tangent (Tandδ) of 0.012 for a frequency of 3.60 GHz. The dielectric constant and the ferroelectric property of the material produced are quite promising for applications in microwave circuits, such as miniaturization and tuning.

Palavras-chave : dielectric constant; ferroelectrics; microwave materials; loss tangent; Sol-Gel; thin films.

        · resumo em Português | Espanhol     · texto em Inglês     · Inglês ( pdf )