Servicios Personalizados
Revista
Articulo
Indicadores
- Citado por SciELO
- Accesos
Links relacionados
- Citado por Google
- Similares en SciELO
- Similares en Google
Compartir
DYNA
versión impresa ISSN 0012-7353versión On-line ISSN 2346-2183
Resumen
GIRALDO, JORGE et al. CONSTRUCTION OF WELDING CURRENT VS. WIRE FEED SPEED CURVES FOR GMAW. Dyna rev.fac.nac.minas [online]. 2009, vol.76, n.157, pp.205-212. ISSN 0012-7353.
This paper describes the development of an experimental procedure for the elaboration of Welding Current vs. Wire Feed Speed curves in GMAW welding process with two electrode stickouts in a short circuiting transfer mode, using an ER70S-6 electrode and a 98%Ar-2%CO2 shielding gas. It was found that the welding current increases proportional (approximately linear) to the wire feed speed and inversely proportional to the electrode stickout when the voltage keeps constant. The results were verified comparing the obtained curves with the theoretical curves under similar working conditions finding a difference of around 20 A between both curves for a tip to work distance of 15 mm. The electrode extension was established indirectly using the pictures of the arc length taken during the experimental procedure.
Palabras clave : GMAW; Wire Feed Speed; Electrode stickout.