SciELO - Scientific Electronic Library Online

 
vol.74 número153SOL-GEL COATINGS DEPOSITED ON STAINLESS STEELS ALLOYS REVIEWHOT CORROSION STUDY OF AISI-SAE 304H ALLOY, BY USING THE ELECTROCHEMICAL IMPEDANCE SPECTROSCOPY TECHNIQUE índice de autoresíndice de assuntospesquisa de artigos
Home Pagelista alfabética de periódicos  

Serviços Personalizados

Artigo

Indicadores

Links relacionados

  • Em processo de indexaçãoCitado por Google
  • Não possue artigos similaresSimilares em SciELO
  • Em processo de indexaçãoSimilares em Google

Compartilhar


DYNA

versão impressa ISSN 0012-7353

Resumo

MUNOZ, JORGE E.  e  CORONADO, JOHN J.. MECHANICAL AND TRIBOLOGICAL ANALySiS OF Fe-Cr-Ni-C AND Ni-Al-Mo COATINGS. Dyna rev.fac.nac.minas [online]. 2007, vol.74, n.153, pp.111-118. ISSN 0012-7353.

In this paper the coatings Ni=89%, Al = 5,5%, Mo=5,5% and Fe=81,8%, Cr=16%, Ni=2%, C=0,2% were evaluated. The coatings were applied by flame-thermal spray technique. The superficial preparation method was sand blasting. Adhesion, shear, abrasive wear, sliding wear and bending tests were made. The coating Fe-Cr-Ni-C presented minor mass loss, as much for abrasive wear as for the sliding wear. The multilayer presented a greater porosity in the base layer (Ni-Al-Mo) than in the outer layer (Fe-Cr-Ni-C), the last one presented greater amount of nonfused particles and oxides. The failure presented in the adhesion test for the samples with multilayer coating was of adhesive and cohesive characteristic. The stress in which the cracks appear by bending moment in the multilayer coatings diminished with the increase of the thickness.

Palavras-chave : Thermal Spray; Wear; Coating.

        · resumo em Espanhol     · texto em Espanhol     · Espanhol ( pdf )

 

Creative Commons License Todo o conteúdo deste periódico, exceto onde está identificado, está licenciado sob uma Licença Creative Commons